VXL Series

Speaker

Model

Tilt angle[deg]

Mounted height[m]

Top of speaker = 1.7m

Bottom of speaker = 1.3m

Audience

Nearest[m]

Farthest[m]

Nearest SPL[dB]

         
Unit
Range

Spatial Point

Distance[m]

Height[m]


Distance[m]

Height[m]

 

Audience Area

Nearest
Farthest
Distance
3m
7m
10m
Height
1.2m
1.2m
SPL
80.0dB
-9.3dB
70.7dB

Spatial Point

Point 1
Point 2
12.0m
15.0m
1.2m
3.0m
69.1dB
66.0dB

About the VXL Selection Assistant

This app is intended to assist in the selection of the most appropriate VXL speaker model for speech reproduction applications. The app will provide an indication of whether good amplified sound can be provided throughout the audience area by calculating the difference in SPL between the nearest and furthest audience members, based on the following three factors and the speaker output attenuation over distance.

  • Speaker position
  • Audience position
  • SPL requirements for the audience area

Good amplified sound can be expected if the SPL range across the audience area is within 10 dB. Be sure to position the audience within the area covered by the speaker and avoid positioning them in out-of-coverage areas.

If the bottom of the speaker sits lower than the audience’s ears, set the tilt angle to 0 degrees. On the other hand, if the bottom of the speaker sits higher than the audience’s ears, adjust the height and tilt angle so that the speaker’s front is pointed at the farthest audience member.

How to use

Specify the following parameters

Speaker

Model:

Select the speaker model

"Wide" means when setting the switch to "Wide Mode".

Tilt angle:

Specifies the mounted angle of the speaker related to the wall

Mounted height:

Specifies the height from the floor to the center of the speaker

Audience

Nearest:

Distance between the speaker and the nearest audience member

Furthest:

Distance between the speaker and the furthest audience member

Nearest SPL*:

SPL (RMS) required for the audience in the front row

Spatial Point

Distance:

Distance between the speaker and the spatial point

Height:

Height of the spatial point from the floor.

Spatial points allow you to measure and compare the SPL at different points in the room.

Audience Area

Distance:

Distance between the front and last rows of the audience area

SPL:

Difference of SPL between the audience sitting in the front and last rows

Spatial Point

The SPL at the two user-placed spatial points.

* You can only specify a value between 55 dB to 80 dB (RMS), which is assumed to be the optimum listening level for speech.

Note

  • The distance attenuation value used by the app is based on the outcome of a simulation using direct 2kHz band pass noise
  • SPL is calculated based on RMS
  • The speech crest factor is assumed to be 10 dB
  • Room acoustics such as reflections or reverberant sound, may result in differences between the result calculated using this app and the real-world outcome.
  • This app does not support calculation for horizontally combined speakers